A Parameter Cannot Be Changed - Siemens SINAMICS G120 Operating Instructions Manual

Entering the parameter value directly
The BOP-2 offers the option of setting the parameter value digit by digit.
Prerequisite
The parameter value flashes in the BOP-2 display.
Procedure
To select the parameter value directly, proceed as follows:
1. Press the OK button for longer than five seconds.
2. Change the parameter value digit-by-digit.
3. If you have entered all of the digits of the parameter value, press the
You have now entered the parameter value directly.
A.5.4

A parameter cannot be changed

When must you not change a parameter?
The converter indicates why it currently does not permit a parameter to be changed:
You have attempted to change
The operating state in which you can change a parameter is provided in the List Manual for
each parameter.
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
If you press the OK button then the BOP-2 jumps to the next digit.
OK button.
a read-only parameter.
A.5 Handling the BOP 2 operator panel
You must change to basic
commissioning to set this
parameter.
Appendix
You must turn the motor off to
set this parameter.
425