Power Module - Siemens SINAMICS G120 Operating Instructions Manual

Description

3.3 Power Module

3.3 Power Module
Important data on the Power Modules is provided in this section. For additional information,
please refer to the relevant Hardware Installation Manual Manuals for your converter
(Page 461).
All power data refer to rated values or to power for operation with low overload (LO).
Which Power Module can I use with the Control Unit?
You can operate the CU250S-2 Control Unit in the "Vector" control mode with the following
Power Modules:
● PM340 1AC
● PM240
● PM240-2 IP20 and push-through system
● PM250
● PM260
Figure 3-1
Figure 3-2
26
Power Modules with degree of protection IP20 FSA ... FSGX
Power Modules with the push-through system FSA ... FSC
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB