Siemens SINAMICS G120 Operating Instructions Manual page 331

Procedure
To safely remove the memory card using BOP-2, proceed as follows:
1. Go to parameter p9400. If a memory card is correctly inserted, then
2. Set p9400 = 2 The BOP-2 displays "BUSY" for several seconds
3. For Bei p9400 = 3 you may remove the memory card.
4. For p9400 = 100, you may not remove the memory card at the
You have now safely removed the memory card using BOP-2.
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
p9400 = 1.
and then jumps to either p9400 = 3 or p9400 = 100.
moment.
In this case, try again by setting p9400 = 2.
Backing up data and series commissioning
9.1 Saving settings on a memory card
331