Siemens SINAMICS G120 Operating Instructions Manual page 329

5. Close the screen forms.
6. Go offline with STARTER.
7. Switch off the inverter power supply.
8. Wait until all LED on the inverter go dark.
9. Switch on the inverter power supply again.
You have transferred the settings from the memory card using STARTER.
Procedure
Proceed as follows to transfer settings from a memory card using BOP-2:
1.
2.
3.
4.
5.
6.
7.
You have transferred the settings from the memory card using BOP-2.
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
Your settings become effective after this power-on reset.
Remove the USB cable if one is inserted in the inverter.
Attach the BOP-2 operator panel to the inverter.
Go to the menu level "EXTRAS".
Start data transfer in the menu "EXTRAS" - "FROM CRD".
Switch off the inverter power supply.
Wait until all LED on the inverter go dark.
Switch on the inverter power supply again.
Your settings take effect after this power-on reset.
Backing up data and series commissioning
9.1 Saving settings on a memory card
329