A.3.5
A parameter cannot be changed
When must you not change a parameter?
The converter indicates why it currently does not permit a parameter to be changed:
You have attempted to change
The operating state in which you can change a parameter is provided in the List Manual for
each parameter.
SINAMICS G120C converter
Operating Instructions, 07/2015, FW V4.7 SP3, A5E34263257B AC
a read-only parameter.
You must change to basic
commissioning to set this pa-
rameter.
A.3 Using the operator panel BOP-2
You must turn the motor off to
set this parameter.
Appendix
395