Installation - Isuzu 1999 RODEO Workshop Manual

Installation

1. Install field coil.
f Align the located portion (1) of the field coil and
compressor.
f Tighten the mounting screw to the specified torque.
Torque: 5N·m (44 lb in)
2. Connect the lead wire connector with the rubber hold
and tighten the screw.
3. Install pulley assembly by using pulley installer
J-33940-A and drive handle J-8092.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–69
4. Install snap ring.
5. Install shim (s).
6. Install the drive plate to the compressor drive shaft
871RW017
7. Install drive plate bolt by using drive plate holder
871RS013
together with the original shim(s)(1). Press the drive
plate by hand.
J-33939 (1) to prevent the drive plate from rotating.
f Tighten the drive plate bolt to the specified torque.
Torque: 13 N·m (113 lb in)
f After tightening the drive plate bolt, check to be sure
the pulley rotates smoothly.
871RW012
871RW014