Maintenance Mode - SATO 9001226(A) Service Manual

4.14 MAINTENANCE MODE

In Maintenance mode, you can further access Service mode, Factory mode and RFID mode for more printer
configuration.
Make sure the Power of the printer is turned off (O).
1.
While pressing the
2.
The printer enters MAINTENANCE mode.
Note:
You may also access MAINTENANCE mode by pressing the FUNCTION button,
simultaneously, switch the Power to On ( I ).
Press arrow buttons to select SERVICE MODE, FACTORY MODE, or RFID MODE, and then press
3.
/
FEED button to enter the selected mode.
TG3 Series Service Manual
Press FUNCTION + +
+ Switch Power to On " I "
or
Press + button
+ Switch Power to On " I "
Select SERVICE
MODE +
FEED button
Select FACTORY
MODE +
FEED button
Select RFID
MODE +
FEED button
and arrow buttons simultaneously, switch the Power to On ( I ).
Section 4: Operation and Configuration
button
* Press
item accordingly. The active arrow
icons are displayed on the screen.
Service Mode
Factory Mode
RFID Mode
, , or button to select
and arrow buttons
Page 4-59