SATO 9001226(A) Service Manual page 88

Section 4: Operation and Configuration
4.12 TEST PRINT MODE (Cont'd)
Item name to be printed
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
Priority Setting
Print Area
Stacker/Rewinder
Ribbon Nonlock
F-Pitch Offset(VR)
Pitch (VR)
Offset(VR)
Darkness (VR)
Pitch Offset
Cut Offset
Backfeed Offset
Slice Level
3) Third piece -- Setting values in both User Mode and Advanced Mode, sensor information and DSW setting
will be printed.
Item name to be printed
Print Speed
Print Darkness
Print Offset H
Print Offset V
Page 4-48
This information will be printed when transmissive sensor is
enabled.
If "Low" is not [0.2 < Low < 1.0], "Low" will be indicated in reverse
color.
If "High" is [0.8 < (High-Low)], "High" will be indicated in reverse
colors.
The validity of priority setting.
"Command" will be printed when this setting is available. If not,
"Internal" will be printed.
Print area setting supported in the existing model "XL4xxe".
"Enabled" will be printed when this setting is available. If not, "Dis-
abled" will be printed.
The validity of stacker/rewinder status detection. "Enabled" will be
printed when this function is on. If not, "Disabled" will be printed.
The validity of ribbon nonlock detection.
"Enabled" will be printed when this function is on. If not, "Disabled"
will be printed.
Pitch offset value for factory default in "mm" scale.
Pitch offset value in "mm" scale.
Offset value for cut position in "mm" scale.
Print darkness setting value.
Tag/Label stop position, cut position, backfeed distance, and sen-
sor slice level.
[T C] = Center hole tag
[T I] = I-mark tag
[T S] = Side hole tag
[T E] = Edge tag
[L G] = Gap label
[L I] = I-mark label
[N S] = Sensor disabled
Print speed.
Print darkness and range settings.
Print offset values.
Description
Description
TG3 Series Service Manual