Adjusting Optional Stacker Timing Belt Tension (St-Tg3) - SATO 9001226(A) Service Manual

Section 6: Checks and Adjustment Procedures

6.22 ADJUSTING OPTIONAL STACKER TIMING BELT TENSION (ST-TG3)

Required tool: Phillips head screwdriver
Measurement :
Detach the Cover (LH) by removing the five screws.
1.
Access and remove the four screws that hold the Cover (RH) to the center frame .
2.
Turn the printer around to access the front of the stacker.
3.
Remove the screw that secures the purple label/tag latch. Remove the latch. Slide toward you the lower
4.
front panel.
Move the pressure shaft of the three media feeding belts up and down for adjustment. Make sure the three
5.
belts have the same belt tension.
If the timing belt cannot be adjusted by this procedure, replace the timing belt based on the procedure, in
6.
the Section 7.28 Replacing Optional Stacker Timing Belt (ST-TG3) of this manual.
[IMPORTANT] Make sure three belts have the same tension.
Page 6-46
Pressure shaft
Loosen the screw
Pressure shaft
Loosen the screw
TG3 Series Service Manual