4.7 INTERFACE MODE (Cont'd)
Setting of IEEE1284
Menu
TG3 Series Service Manual
From INTERFACE
BOARD SETTING
screen
FEED
ONLINE
button
button
FEED
ONLINE
button
button
Select IEEE1284 +
ONLINE
MULTI + FEED button
button
FEED
ONLINE
button
button
Displayed only
when STATUS5
is set
FEED
ONLINE
button
button
FEED button
Proceed to IGNORE
CAN/DLE screen of
INTERFACE MODE menu
IEEE1284 CONFIGURATION
Setting the motion of SELECT IN signal for IEEE1284.
CENTRONICS : SELECT IN signal (36-pin) becomes LO (low) constantly
IEEE1284 : Motion based on the IEEE1284 standards will be taken (Becomes
LO for Compatible Mode, HI for other modes)
The initial value is IEEE1284.
Note : As for the use of PC98, a communication failure occurred when SELECT
IN signal remained HI in the SR series printers. This additional setting is to
eliminate the communication failure.
Section 4: Operation and Configuration
* Press
,
,
or
item or set the value accordingly.
The active arrow icons are displayed
on the screen.
* Pressing FUNCTION button on each
screen will revert to INTERFACE
MODE menu.
Select CENTRONICS or
IEEE1284 + 1ITEM
+ FEED button
ONLINE
button
FEED
button
Description
button to select
Page 4-19