Maintenance Mode - SATO HR2 Series Operator's Manual

3.15 MAINTENANCE MODE

In Maintenance mode, you can further access to Service mode for more printer configuration.
1. Make sure the Power of the printer is turned off (O).
2. While pressing the + and - buttons simultaneously, switch the Power to On (I).
The printer enters MAINTENANCE mode.
Note:
You may also access to MAINTENANCE mode by pressing the + and - buttons, and < arrow buttons simul-
taneously, switch the Power to On (I).
3. Press <, > arrow buttons to select SERVICE MODE and then press FEED button to enter to the selected
mode.
Note:
Please note that FACTORY MODE is strictly for SATO authorised service personnel use. Any mis-
adjustment or setting may disrupt the performance of the printer and may cause malfunction.
HR2 Series Operator Manual
Press + & - buttons
& Switch Power to On " I "
Or
Press + & - & < buttons
& switch Power to On "I"
Select SERVICE
MODE +
FEED button
Service Mode
Section 3: Operation and Configuration
* Press or button to select item
accordingly. The active arrow icons
are displayed on the screen.
Page 3-55