SATO 9001226(A) Service Manual page 110

Section 4: Operation and Configuration
4.16 FACTORY MODE (Cont'd)
Menu
Page 4-70
FACTORY MODE
Resetting a counter in the printer.
The 6 items below are selectable.
NONE..................No reset
ALL......................Printer settings and all of the counters are reset.
COUNTERS..........Reset all of the counters.
LIFE.....................Reset only life counter.
HEAD...................Reset only head counter.
CUT......................Reset only cut counter.
Press arrow buttons to move cursor, and then press FEED .
/
The initial value is NONE.
Use this to display the value of counters in the printer.
You can select from the four below items:
NONE.....None displayed
LIFE........Displays the life counter
HEAD......Displays the head counter
CUT.........Displays the cut counter
Press arrow buttons to move cursor, and then press FEED .
/
Initial value is NONE.
Use this to display the value of the life counter in the printer.
To exit, press FEED or ONLINE .
Use to show value of head counter in the printer.
To exit, press FEED or ONLINE .
Use this to show the value of the cut counter in the printer.
To exit, press FEED or ONLINE .
Use this to adjust the LCD screen brightness and darkness.
Press arrow buttons to enter value, and then press FEED .
/
You cannot clear the setting by resetting the counter.
Press FEED to save the set value and go to SERIAL NO.
Press ONLINE to go to COUNTER DISPLAY without saving the set value.
Enter the serial number here.
Use the arrow buttons to move the cursor.
/
Enter the serial number using the
the number.
The initial value is 00000000.
Assignable characters are 0 to 9 and A to Z.
You cannot clear the setting by resetting the counter.
Description
arrow buttons, and press FEED to set
/
TG3 Series Service Manual