Optional Accessories Specifications - SATO 9001226(A) Service Manual

Section 2: Basic Specifications

2.2 OPTIONAL ACCESSORIES SPECIFICATIONS

LARGE-SIZED STACKER SPECIFICATIONS
Model name
Maximum stack height
Tag feed speed
Media Type
Media Size Tag
Thickness
Tag pressure
Sensor
Communication
(Connection)
Power supply
Motor
Dimensions
Weight
Fixation (Installation) method
Accessories
Page 2-8
5.9" (150 mm) (Paper thickness 0.01" (0.26 mm), approximately 500 tags)
9.8" per second (250 mm/second)
Tag only (Use of label is not acceptable)
* Refer to the Consumable Specifications for more details.
Make sure the tag size meets the following conditions.
Width: 1.3" to 3.3" (32 to 83 mm)
Pitch: 1" to 5.9" (25 to 150 mm)
* Use the optional weight when the tag length is 3.5" (90 mm) or greater.
* Use the optional spacer when the length of laminated tag and glossy tag are 3.5"
(90 mm) or more.
Tag: 0.006" to 0.013" (0.159 to 0.33 mm)
Some restrictions may apply to the tag size due to tag curling when the diameter of
tag roll core is 3 inches (76.2 mm).
Outputs the "stacker full" signal to the EXT (the printer) at the time of error
Input: Amphenol 14-pin Male (EXT connector connection)
* Connecting with the computer (Rewinder and daisy connection inside)
EXT terminal (for handshake):
#3 (Input): Winding motor control
#5 (Output): Rewinder full + stacker full
#6 (Input): Stacker motor control
Output: Amphenol 14-pin Female (EXT connector connection)
* Connecting with the rewinder (RWG500/RWS300)
EXT terminal (for handshake):
#3 (Input): Winding motor control
#5 (Output): Rewinder full
Supplied from the printer unit (EXT connector).
EXT terminal:
# 2 : GND
# 12 : DC+24V
# 13 : DC+5V
Stepping motor (Interfaces with the printer)
2-phase unipolar type stepping motor
W 8.6" X D 9.6" X H 11.8" (W 219 X D 245 X H 300 mm)
Tag stopper, Joint plate, Optional weight (For the tag length of 90 mm or more),
Optional spacer with magnet (Use the optional spacer when the length of laminated
tag and glossy tag are 90 mm or more), Instruction guide for optional spacer.
ST-TG3
Weight load type
Movable tag full sensor
occurrence.
7.5" (3.4 kg)
Simple fixation by joint plate.
* Can be set by the users.
TG3 Series Service Manual