SATO 9001226(A) Service Manual page 72

Section 4: Operation and Configuration
4.11 RFID USER MODE (Cont'd)
During Offline mode, press FUNCTION button to display the operational icon menu. Press arrow buttons
1.
to select the RFID USER MODE.
The RFID USER MODE icon is displayed only when the RFID MODULE was ENABLE in the Maintenance
mode. Please refer to Section 4.16 Factory Mode for details.
When RFID MODE is displayed, press the FEED button to enter RFID mode for adjustment.
2.
Note:
PASSWORD may prompt on the display if SET PASSWORD is set to ON in the Service mode. Please
refer to Section 4.15 Service Mode for details on how to enter password.
RFID LIFE COUNT is first displayed. Press the FEED button repeatedly will switch to the next setting
3.
options as shown above. To return to the previous setting option, press ONLINE button.
When the desired setting option is displayed, press arrow buttons to select the item or to set the value and
4.
then press FEED button to save the setting.
Menu
Page 4-32
RFID USER MODE
Showing the total number of RFID write after factory clear.
SUCCESS : Shows the number of write success to RFID tag.
FAILURE : Shows the number of write failure to RFID tag.
TOTAL : Shows the total print quantity.
This counter can be reset by factory clear only
Showing the total number of RFID writes.
SUCCESS : Shows the number of write success to RFID tag.
FAILURE : Shows the number of write failure to RFID tag.
TOTAL : Shows the total number of writes.
Initializing RFID current counter.
Selecting YES and pressing FEED button will initialize the RFID current coun-
ter.
The initial value is NO.
RFID life counter cannot be reset through this screen.
Setting the printer motion at the time of RFID tag error. Also, this section shows
how to recover from an RFID ERROR state when the error count exceeds the
specified limit.
RELEASE : The printer keeps writing tags and discarding defective tags up to a
specified quantity even when a tag error occurs. Then the printer emits a RFID
ERROR message and pauses the operation when the error count exceeds the
specified limit.
RETRY : When a tag error occurs, the printer attempts to write the same data
based on the specified quantity. If the tag writing still fails, the printer emits a
RFID ERROR message and pauses the operation.
The initial value is RETRY.
This screen is displayed only when MODULE SELECT is set to ThingMagic in
the Service Mode.
Setting the counter for void and reprint tags at the time of tag error.
Input range is from 0 to 9.
The initial value is 0.
Description
TG3 Series Service Manual