Replacing Lid Latch Sensor - SATO 9001226(A) Service Manual

Section 7: Replacement Procedures

7.22 REPLACING LID LATCH SENSOR

With the power supply is off, lift up the main cover.
1.
Detach the Operator Panel assembly based on step 2 and step 3 of Section 7.15 Replacing Operator
2.
Panel PCB .
Below the purple Lid Latch lever , remove a screw (1) to detach the Lid Latch sensor assembly .
3.
Disconnect the wiring harness of the Lid Latch sensor (3).
4.
Remove the screw (2) securing the Lid Latch sensor (3) to the Open sensor bracket (4).
5.
Replace the defective Lid Latch sensor (3) as necessary and reverse the above procedures for reassem-
6.
bly.
Note: Insert the wiring harness firmly and arrange the wiring harnesses to ensure that they are not
pinched during installation.
After replacement, check the Lid Latch sensor condition based on Section 6.11.2 To check Head Open
7.
sensor and Lid Latch Sensor.
Remove the connector
Page 7-36
Lid Latch sensor assembly
1
3
4
TG3 Series Service Manual
2