SATO 9001226(A) Service Manual page 95

4.12 TEST PRINT MODE (Cont'd)
Item name to be printed
Check
Cmd Err (Command Error)
P-Code (Protocol Code)
Euro Code
I/F-1
I/F-2
Pitch (LCD)
Offset (LCD)
Darkness (LCD)
FRM1 CHK SUM
FRM2 CHK SUM
FRM3 CHK SUM
FRM4 CHK SUM
TG3 Series Service Manual
The setting of calendar check.
"Enabled" will be printed if calendar check is on. If not, "Disabled"
will be printed.
Note that this information will not be printed without installing the
calendar IC.
The setting of command error display.
"Error" will be printed if this setting is enabled. If not, "Warning" will
be printed.
Protocol code setting.
For standard protocol, "Standard" will be printed. For non standard
protocol, "Non Standard" will be printed.
Also, the protocol code stored in the printer will be printed.
Euro code setting.
Interface setting.
If the interface is not connected, "----" will be printed.
Connection status with Keypad.
If the Keypad is connected, "Keypad" will be printed. If not, "-----"
will be printed.
Print position specified via LCD display will be printed.
Cut position specified via LCD display will be printed.
Print darkness specified via LCD display will be printed.
Checksum value in firmware area.
(A): Checksum including firmware and built-in fonts.
(P): Checksum including firmware only.
Note that checksum value may change by firmware version.
Extended memory, LCD data, UNICODE conversion table, check-
sum value of TTF header area. Note that checksum value may
change by destination.
Checksum value of TTF/ outline font.
Checksum value when TTF/ outline font is not registered will be
"0000".
Note that checksum value may change by destination.
Checksum value of Kanji ROM area. Note that checksum value
may change by destination.
Checksum value without Kanji ROM will be "0000".
Section 4: Operation and Configuration
Description
Page 4-55