SATO 9001226(A) Service Manual page 241

8.6 OFFSET POSITION ADJUSTMENT (Cont'd)
8.6.4 Adjustment of Media Feeding Position
A feeding error in automatic feeding function or a detection error by the media sensor may cause the incorrect
print position of the first label or tag right when executing automatic feeding function. The loading offset is to
correct the print position right after performing auto media feed.
Note that this adjustment is reflected in the print position right after executing auto media feed only, not for the
print position after paper ejection or normal feeding motion.
The default value and its motion are described below.
Loading offset
Discharging roller
Starts auto paper feed
Feeds the top of tag to the
base reference point
Feeds the tag to the
ejection roller (Detects
whether the tag is wasted
or not)
Backfeed to the base
reference point
TG3 Series Service Manual
Item
Tag Center hole
Side hole
Edge
I-Mark
Label Gap
I-Mark
Sensor off
Platen roller
(Base reference point)
Misalignment at the top of tag
( - ) direction ( + ) direction
Loading offset (Media feeding position adjustment)
Section 8: Appendix
Default value
+00
+00
+00
+00
+00
+00
+00
Feed roller
Page 8-11