8.5 BASE REFERENCE POINT
The base reference point is the point at which one determines the print and cut positions.
.
I-Mark Label
Center Hole Tag
I-Mark Tag
The center of each mark or hole is defined as the base reference point.
In Service Mode, using the offset function for each label and tag will eliminate an unprintable area.
TG3 Series Service Manual
Base
reference
point
Base
reference
point
Base
reference
point
Section 8: Appendix
Gap Label
Side Hole Tag
R-Corner (Notch/Edge) Tag
Base
reference
point
Base
reference
point
Base
reference
point
Page 8-7