Offset Position Adjustment - SATO 9001226(A) Service Manual

Section 8: Appendix

8.6 OFFSET POSITION ADJUSTMENT

The offset function (print, cut and backfeed) of the printer are as follows.
8.6.1 Adjustment of Print Position
Adjustment screen Mode: Pitch Position+/-0.15" (3.75 mm) for all media types
Online command (ESC #)+/-2" (50 mm) for each media when received
Service Mode: Pitch Offset+/-99dot for each media
8.6.2 Adjustment of Cut Position
Adjustment Mode: Offset Position+/-0.15" (3.75 mm) for all media
Online command (ESC #)+/-2" (50 mm) for each media when received
Service Mode: Cut Offset+/-99dot for each media
Print or cut operation will be performed by the value of which each item is added at every single job.
The default values in Service mode
Adjusting stop position
Adjusting cut position
Adjusting backfeed distance
Page 8-8
Item
Tag Center hole
Side hole
Edge
I-Mark
Label Gap
I-Mark
Tag Center hole
Side hole
Edge
I-Mark
Label Gap
I-Mark
Sensor off
Tag Center hole
Side hole
Edge
I-Mark
Label Gap
I-Mark
Sensor off
TG308 TG312
(203 dots per (305 dots per
inch or 8 dots inch or 12
per mm) dots per mm)
+00 +00
+00 +00
+00 +00
-12 -18
-12 -18
-36 -54
+00 +00
+00 +00
+00 +00
-12 -18
-12 -18
-36 -54
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
TG3 Series Service Manual