Section 7: Replacement Procedures
7.1 REMOVAL OF HOUSING COVER
Before remove the casing of the printer, turn Off the power of the printer. Disconnect all the cables attached to
the printer. If you need to remove the CONT board (main PCB), disconnect the attached interface card.
7.1.1 To remove Main cover
Lift up the main cover . From the two sides of the cover
1.
joint, lightly push from inside outwards and then leave up to
remove.
7.1.2 To remove the left housing cover
Base on the Media ejection slot as the front, locate the
2.
large housing cover that is the left-most panel. Locate the
two screws at the bottom part of this panel or cover. With a
Phillips screwdriver, remove these two screws .
From the bottom of the printer, lift the cover upward as
3.
shown and remove the cover.
7.1.3 To remove the top left housing cover
Unscrew 5 screws as indicated and remove the left housing cover from the printer.
4.
Page 7-2
screws
Top left cover
Main cover
Media
ejection slot
TG3 Series Service Manual