6.16 ADJUSTING PRINT HEAD POSITION (Cont'd)
Fine Tuning of Head Balance with the Adjustment Screw
Adjust the screw of head balance plate for optimal printing position.
2.
Loosen the screw: Print on the engine frame side gets darker. Paper leans to the engine frame side.
Tighten the screw: Print on the head lock lever side gets darker. Paper leans to the head lock lever side
Perform a test print to check the print quality. The print darkness on the right and left sides should be the
3.
same. There should not have any label/tag meandering.
Repeat this procedure until proper adjustment is achieved. If poor print quality persist, adjust the print head
alignment as described in following.
TG3 Series Service Manual
Section 6: Checks and Adjustment Procedures
Head ASSY
Head balance adjustment screw
Head balance plate
Page 6-37