SATO 9001226(A) Service Manual page 73

4.11 RFID USER MODE (Cont'd)
Menu
TG3 Series Service Manual
RFID USER MODE
Printing a slash on a tag when an RFID tag error occurred.
YES : Prints a slash at the time of RFID tag error.
NO : Not printing a slash at the time of RFID tag error.
The initial value is NO.
Setting output format.
BIN : Binary format.
ASCII : ASCII format.
HEX : HEX format.
The initial value is ASCII
Showing RFID module version.
Version display may differ by the module to be connected.
Setting the RFID tag position from the top of form.
The input range is between 0.79" (20 mm) and 9.45" (240 mm).
The initial value is 0.79" (20 mm).
Performing RFID tag read or write test.
READ : Start read test. READ TEST menu is displayed when selected.
WRITE : Start write test. WRITE DATA menu is displayed when selected.
The initial value is READ.
This screen appears only when TAKAYA or ThingMagic is set to MODULE
SELECT in the Service Mode.
Performing RFID tag read test.
Select YES and press FEED button to proceed the RFID reading test.
The initial value is NO.
Showing the data read from RFID tag.
Press arrow buttons to switch between pages.
/
This message appears when RFID tag is read successfully.
Press FEED button to exit from this screen.
This message appears when failing to read RFID tag.
Select YES and press FEED button to repeat the RFID reading test.
If NO is selected, printer goes to ONLINE mode.
The initial value is NO.
Entering test data to be written to RFID tag.
Press arrow buttons to key in the test data and press
/
to move the cursor to next digit. Press FEED button to enter the setting.
The initial value is 00000000.
This screen appears only when TAKAYA or ThingMagic is set to MODULE
SELECT in the Service Mode.
Section 4: Operation and Configuration
Description
arrow buttons
/
Page 4-33