SATO 9001226(A) Service Manual page 80

Section 4: Operation and Configuration
4.12 TEST PRINT MODE (Cont'd)
Item name to be printed
JP9
2) Second piece -- Interface setting and setting values such as print position will be printed.
Item name to be printed
I/F-1
I/F-2
Pitch (LCD)
Offset (LCD)
Darkness (LCD)
Page 4-40
JP9 on CONT board (Main PCB).
"0" must be selected for this setting.
Interface setting details.
If an interface is not connected, "----" will be printed.
Connection status with Keypad.
If the Keypad is connected, "Keypad" will be printed. If not, "-----"
will be printed.
Print position specified via LCD display will be printed.
Cut position specified via LCD display will be printed.
Print darkness specified via LCD display will be printed.
Description
Description
TG3 Series Service Manual