SATO 9001226(A) Service Manual page 164

Section 6: Checks and Adjustment Procedures
6.10 ADJUSTING CUTTER SENSORS (Cont'd)
6.10.2 To adjust I-Mark sensor
Ensure the printer power is turned off. Detach the cutter unit
1.
without disconnecting the connector.
First, lift up the Main cover , unscrew the shaft that holds
the cutter unit in place, removed the shaft and set aside.
Carefully lift and pull out the cutter unit without disconnect
the connector.
Enter to MAINTENANCE MODE, select SERVICE MODE
2.
and then press FEED button. Refer to Section 4.14 Main-
tenance Mode for more details.
In service mode with SENSOR LEVEL highlighted, press
3.
FEED repeatedly until CUTTER SENSOR GAP/CH is
displayed. Then press the
CUTTER SENSOR I-MARK.
This screen is to check the sensor responses.
Set the blank media (label or tag) at the cutter sensor,
4.
check the LCD screen display, then relocate the media so
that the I-Mark is oriented over the sensor directly and
check the screen again.
The LCD screen will display [0] if blank media (label or tag)
is set on the I-Mark sensor and display [1] if I-Mark portion
is set.
If the LCD screen does not response correctly, proceed the
following steps to adjust the sensor level.
Page 6-26
/ arrow buttons to select
3
shaft
1
Cutter unit
TG3 Series Service Manual
2