SATO 9001226(A) Service Manual page 57

4.7 INTERFACE MODE (Cont'd)
Menu
TG3 Series Service Manual
LAN/Wireless LAN CONFIGURATION
This screen allows user to select the LAN/ Wireless LAN configurations based
on either the setting on interface board or the setting of LCD.
BOARD : Priority on current interface board settings
Select BOARD and press FEED button will proceed directly to PROTOCOL
setting.
LCD : Priority on LCD settings
Select LCD and press FEED button will continue to IP ADDRESS setting.
The initial cursor position is at BOARD.
Note : Changed settings will be in effect from the next power on.
Setting the IP address, follow by the Subnet mask and then Gateway address
of LAN/ Wireless LAN.
Press arrow buttons to change the setting value and press
/
buttons to move the cursor to next digit.
Press FEED button to save the setting.
Note : Changed settings will be in effect from the next power on.
Setting the Port number 1, 2 and 3 of Wireless LAN. These screens are dis-
played only when Wireless LAN interface board is installed.
Press arrow buttons to change the setting value and press
/
buttons to move the cursor to next digit.
Press FEED button to save the setting.
Setting range is between 00000 and 65535. The initial value for Port number 1
is 01024, Port number 2 is 01025 and Port number 3 is 09100.
Note : Changed settings will be in effect from the next power on.
Select the Wireless LAN mode as 802.11 Ad Hoc, Ad Hoc or Infrastructure.
This screen is displayed only when Wireless LAN interface board is installed.
The initial selection is 802.11 Ad Hoc.
Note : Changed settings will be in effect from the next power on.
Set the SSID of Wireless LAN.
Press arrow buttons to change the setting value and press
/
buttons to move the cursor to next digit.
Alphabet (Upper/Lower case) and numeric up to 32 digits can be entered.
The input character advances in following sequence with every pressing of the
arrow button. Pressing
This screen is displayed only when Wireless LAN interface board is installed.
Note : Changed settings will be in effect from the next power on.
Set the Channel of Wireless LAN.
Setting range is between 01 and 14.
The initial value is 01.
This screen is displayed only when Wireless LAN interface board is installed.
Note : Changed settings will be in effect from the next power on.
Section 4: Operation and Configuration
Description
arrow reverses the sequence.
/
arrow
/
arrow
/
arrow
Page 4-17