SATO 9001226(A) Service Manual page 15

INTERFACES
Interface Board
Optional Plug-in interface
boards
SENSING
Gap/ Center Tag hole
(Transmissive)
I-Mark (Reflective)
Side Tag hole
R-corner /Notch Tag hole
Jump hole
Head Open
Ribbon End
Lid latch open
Cutter
SELF-DIAGNOSIS FUNCTION
CHARACTER FONT CAPABILITIES
MATRIX FONTS
WB text
WL text
S text
M text
U text
XU
XS
TG3 Series Service Manual
1) Plug-in Interface board (1 slot)
2) EXT (External) connector (for optional devices such as stacker and label
rewinder)
3) RS-232C D-sub 9-pin type (for keypad only)
1) RS-232C (High-Speed) I/F board
2) IEEE1284 (ECP/Compatible) I/F board
3) LAN I/F board
4) Wireless (LAN IEEE802.11b/g)/ Wired LAN I/F board
The board comes with a wired LAN connector. However, the simultaneous use of
a wireless connection and wired connection is not possible.
5) USB I/F board (Full-Speed)
Position & Sensitivity Adjustable
Position & Sensitivity Adjustable
1) Broken head element check
2) Paper end detection
3) Test print
4) Ribbon end detection
5) Ribbon near-end detection
6) Kanji data check
7) Head open
8) Lid latch open
9) Cutter error
10) Stacker full (Only when an optional stacker is installed)
11) Take-up spindle full (Only when an optional rewinder is installed)
18 dots W x 30 dots H (Alphanumeric, symbols)
28 dots W x 52 dots H (Alphanumeric, symbols)
8 dots W x 15 dots H (Alphanumeric, symbols)
13 dots W x 20 dots H (Alphanumeric, symbols)
5 dots W x 9 dots H (Alphanumeric, symbols)
5 dots W x 9 dots H (Alphanumeric, symbols)
17 dots W x 17 dots H (Alphanumeric, symbols)
Section 2: Basic Specifications
Sensitivity Adjustable
Sensitivity Adjustable
Sensitivity Adjustable
Sensitivity Adjustable
Fixed
Fixed
Fixed
Page 2-3