SATO 9001226(A) Service Manual page 92

Section 4: Operation and Configuration
4.12 TEST PRINT MODE (Cont'd)
1) First piece -- Printer model name, firmware version, print head life expectancy, various serial numbers,
sensor information, and DSW setting will be printed.
Item name to be printed
Model
Firm Ver
Font Ver
Firm Date
Life or Life Counter
Head1 (Head Counter 1)
Head2 (Head Counter 2)
Head3 (Head Counter 3)
Cutter or Cutter Counter
Head Check or
Head-Check [All]
S/N
C S/N
PCB Rev.
I/F Rev.
Reflective Sensor
Low [Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
DSW1
DSW2
JP9
Page 4-52
Printer model name.
Firmware version.
Font version.
Created date of firmware.
Print format is indicated by the last 2 digits of the year, month and
day.
Printed life expectancy in "m" scale.
Print head life expectancy in "m" scale.
The number of paper being cut.
Checks print head condition and prints its result.
*Check result will not be indicated in reverse colors.
Serial number of printer.
Serial number of CONT board (Main PCB).
CONT board (Main PCB) version.
Interface version.
This information will be printed when reflective sensor is enabled.
*Setting value will not be indicated in reverse colors.
This information will be printed when transmissive sensor is
enabled.
*Setting value will not be indicated in reverse colors.
DSW setting on CONT board (Main PCB).
When RS-232C interface board is connected, the DSW information
on the interface board will be printed.
JP9 on CONT board (Main PCB).
"0" must be selected for this setting.
Description
TG3 Series Service Manual