SATO 9001226(A) Service Manual page 116

Section 4: Operation and Configuration
4.18 DOWNLOAD MODE (Cont'd)
Make sure the Power of the printer is turned off (O).
1.
While pressing the
2.
The printer enters DOWNLOAD READY mode.
3.
Using MS-Prompt command, send in the data for downloading from the host computer to the printer.
4.
Menu
Page 4-76
arrow button, switch the Power to On ( I ).
DOWNLOAD MODE
Waiting to receive download data.
The following data will be received from the PC and written to main ROM.
(1) Firmware data
(2) Font / Logo data
(3)TRUETYPE font
When Firmware data is received, it goes to RECEIVING...screen.
When Font, Logo and TRUETYPE font are received, it goes to FONT
DOWNLOAD READY screen.
Waiting to receive font data.
When downloading the font for the first time, it goes to RECEIVING... screen.
To overwrite or delete font data, it goes to DELETING... screen.
Deleting font data.
The gauge shown on the lower portion of screen indicates deleting status of
download data.
To overwrite font data after deleting the font data, it goes to RECEIVING...
screen.
To delete the font data, it goes to FONT DELETE COMPLETED screen.
Receiving download data.
The gauge shown on the lower portion of screen indicates downloading status.
After receiving the download data, it goes to WRITING... screen.
Writing download data.
The gauge shown on the lower portion of screen indicates writing status of
download data.
After writing the download data, it goes to FONT REGISTRY COMPLETED
screen.
Verifying download data.
The gauge shown on the lower portion of screen indicates verification status of
download data.
After verifying the download data, it goes to PROGRAM DOWNLOAD COM-
PLETED screen.
Completion of download.
Emitting three short beeps when program download is completed.
Press FEED button to go to DOWNLOAD READY screen.
Description
TG3 Series Service Manual