Section 7: Replacement Procedures
7.18 REPLACING JUMP HOLE SENSOR (cont'd)
To replace Jump hole sensor (lower) board
Slide the Media guide knob to the widest. Remove two screws (10) securing the Bracket (Jump sensor)
10.
(11) to the Media route frame.
Disconnect the Lower Jump hole wiring harness and withdraw the Bracket (Jump sensor) (11) with the
11.
sensor board attached.
Remove two screws (12) securing the Lower Jump hole sensor board (13) and replace it as necessary.
12.
Reverse the above procedures for reassembly.
13.
Insert the wiring harness firmly and arrange the wiring harnesses to ensure that they are not pinched
during installation.
After replacement, adjust the Jump hole sensor condition based on Section 6.9.5 Jump hole Sensor
14.
Sensitivity Adjustment .
Page 7-30
12
13
11
10
13
11
TG3 Series Service Manual