Adjusting Backfeed Offset - SATO 9001226(A) Service Manual

6.8 ADJUSTING BACKFEED OFFSET

This setting adjusts the backfeed distance after or before a print out.
Enter to MAINTENANCE MODE, select SERVICE MODE and then press
1.
FEED button. Refer to Section 4.14 Maintenance Mode for more details.
Press the arrow buttons to select BACKFEED OFFSET on the
2.
/
SERVICE MODE screen, and press the FEED button. The BACKFEED
OFFSET screen appears.
Backfeed distance can be adjusted for each media type.
Press the / arrow buttons to select the media type. Press
3.
buttons to enter the value within the range of ±00 to 99 dots.
See the table below for the media type corresponding to the printer model.
Media Sensor
Tag Center hole
Side hole
Edge
I-Mark
Label Gap
I-Mark
Others Not sensor
Press the FEED button to save the value.
4.
Perform the test print to see if tags or labels are backfeed properly.
5.
TG3 Series Service Manual
Section 6: Checks and Adjustment Procedures
/ arrow
TG308 TG312
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
+00 +00
Page 6-11