SATO 9001226(A) Service Manual page 209

7.16 REPLACING GAP SENSOR (cont'd)
On top of the Media route frame assembly , press the tab of the purple Pitch sensor guide (6) and slide
8.
it outwards.
Remove a screw (7) of the Media guide (8) that clamped on the Media route frame assembly (4) and
9.
the printer frame .
On the side of the Lid Latch assembly (9), unscrew two screws (10) to remove the Plate (F/R position)
10.
(11) that holds the Lid Latch . Remove the plastic roller (12) attached to the shaft and set side.
Remove the Media route frame assembly (4) from the printer frame (13).
11.
From the mechanism side of the printer, remove four screws (14) securing the Media route frame
assembly (4) to the printer frame (13).
From the Media route frame assembly (4), remove two screws (15) attaching to the Frame support A
(16) and then remove the screw (17) attaching to the Shaft (support) (18).
Carefully disconnect the attached wiring harnesses , taking care not to cut off the cables as these are
12.
very fine. Remove the Media route frame assembly from the printer frame .
TG3 Series Service Manual
7
8
6
18
14
16
Section 7: Replacement Procedures
9
12
11
10
13
15
4
17
Page 7-25