SATO 9001226(A) Service Manual page 11

1.3 PARTS IDENTIFICATION (cont'd)
Internal view when Main cover is opened (Front view)
10
11
12
13
14
15
Ribbon take-up spindle (coreless)
10
Used to wind up the used ribbon without using
core.
Print head assembly
11
This component is used to print on the media.
Perform maintenance at regular intervals.
Cutter assembly
12
This assembly consist of cutter as well as the
cutter sensor assembly.
TG3 Series Service Manual
Head balance adjustment knob
13
To adjust print head balance to obtain
consistent print out across media.
Head Alignment adjustment knob
14
To adjust print head alignment to obtain
consistent print out across media.
Head lock lever
15
Used to open and close the print head.
Section 1: Introduction
Page 1-5