SATO 9001226(A) Service Manual page 93

4.12 TEST PRINT MODE (Cont'd)
2) Second piece -- Setting values in Service Mode, sensor information, VR (Potentiometer), offset values for
each paper type will be printed.
Item name to be printed
Reflective Sensor
Low [Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
Priority
Print Area
Stacker
Nonlock
F-Pitch (VR)
Pitch (VR)
Offset(VR)
Darkness (VR)
Pitch
Cut
Back
Slice
TG3 Series Service Manual
This information will be printed when reflective sensor is enabled.
*Setting value will not be indicated in reverse colors.
This information will be printed when transmissive sensor is
enabled.
*Setting value will not be indicated in reverse colors.
The validity of priority setting.
"Command" will be printed when this setting is available. If not,
"Internal" will be printed.
Print area setting supported in the existing model "XL4xxe".
"Enabled" will be printed when this setting is available. If not, "Dis-
abled" will be printed.
The validity of stacker/ rewinder status detection. "Enabled" will be
printed when this function is on. If not, "Disabled" will be printed.
The validity of ribbon nonlock detection.
"Enabled" will be printed when this function is on. If not, "Disabled"
will be printed.
Pitch offset value for factory default in "mm" scale.
Pitch offset value in "mm" scale.
Offset value for cut position in "mm" scale.
Print darkness setting value.
Tag/Label stop position, cut position, backfeed distance, and sen-
sor slice level.
[T C] = Center hole tag
[T I] = I-mark tag
[T S] = Side hole tag
[T E] = Edge tag
[L G] = Gap label
[L I] = I-mark label
[N S] = Sensor disabled
[Pitch] = Paper stop position
[Cut] = Paper cut position
[Back] = Backfeed distance
[Slice] = Sensor slice level
Section 4: Operation and Configuration
Description
Page 4-53