Replacing Optional Stacker Pcb (St-Tg3) - SATO 9001226(A) Service Manual

7.27 REPLACING OPTIONAL STACKER PCB (ST-TG3)

Before proceeding, switch off the printer and remove the optional Stacker unit installed at the front of the
1.
printer.
On the left side of the stacker unit, remove five screws (1) to detach the Cover (LH) (2) as shown.
2.
Remove two screws (3) securing the Stacker PCB (4) to the stacker unit frame .
3.
Disconnect the two wiring harnesses from the defective Stacker PCB (4) and replace it as necessary.
4.
Reverse the above procedures for reassembly.
5.
Insert the wiring harnesses firmly and arrange the wiring harnesses to ensure that they are not pinched
during installation.
TG3 Series Service Manual
3
4
Section 7: Replacement Procedures
3
4
2
1
1
Page 7-41