4.12 TEST PRINT MODE (Cont'd)
Menu
TG3 Series Service Manual
TEST PRINT MODE
Setting ink roller motion during test print.
NO : No ink roller action will be taken.
YES : Ink roller action will be taken during test print.
The initial value is NO.
Adjusting the print and cut positions.
Press
arrow buttons to change the setting value and press
/
buttons to toggle between PITCH POSITION and OFFSET POSITION setting.
Both setting range are ±0.15" (3.75 mm) and are adjustable by 0.01" (0.25
mm).
The initial value is +0.00" (0.00 mm).
Press FEED button to start test printing.
Test print is in progress
Press FEED button while printing will pause the test print operation.Press
FEED again to continue.
Section 4: Operation and Configuration
Description
/
arrow
Page 4-37