Warning Message - SATO 9001226(A) Service Manual

5.1 ERROR SIGNAL TROUBLESHOOTING (Cont'd)

5.1.3 Warning Message

Note that the printer will continue issuing tag/label while detecting a warning message.
No. WARNING DISPLAY
01 RIBBON NEAR END
02 BUFFER NEAR FULL
03 COMMAND ERROR
04
05
TG3 Series Service Manual
LED BUZZER
ONLINE: - 1) Remaining ribbon length
On becomes short.
ERROR:
To clear error: Head open
Off
(Ribbon replacement)
ONLINE: - 1) Free space for receive
On buffer is low.
ERROR: To clear error: Cancel print
Off operation or Data to create
more than 1.95MB free space
in receive buffer
ONLINE: 1 short 1) Detecting improper com-
On Beep mand in print data.
ERROR: 2) Print data is outside the
Off printable area.
• This screen appears only
when command error dis-
play is disabled in
Advanced Mode.
To clear error: Normal data
reception
ONLINE: - 1) This message will be dis-
On played after detecting and
clearing an electrical dis-
ERROR:
connection error of print
Off
head temporarily with the
FEED button.
To clear error: Power Off
(Print head replacement)
ONLINE: - 1) The reference position is
Off changed by the <#> com-
mand.
ERROR:
Off • This warning appears only
when [ADJUST FEED
ACTION] is set to "STOP"
in Advanced Mode, paper
type is tag and cutter
motion is "ON".
To clear error: Press ONLINE
button.
ERROR CONDITION
Section 5: Troubleshooting
CORRECTIVE ACTION
1) Change ribbon.
1) Cancel print operation or data
to create more than 1.95MB free
space in receive buffer to clear
an error.
1) Check data
2) Adjust print data and base
reference point offset not to
exceed the printable area.
1) Print head replacement
1) Remove a tag and press the
printer and press ONLINE
button. Or set [ADJUST FEED
ACTION] to "CONTINUE" in
Advanced Mode.
Page 5-7