7.9 REPLACING TIMING BELT (PLATEN) (cont'd)
Loosen the adjustment screw of tension bracket as shown, if necessary. And remove the Timing belts in
6.
numerical order from (5) to (10) for replacement.
These are the Timing belt M266 (5), Timing belt M290 (6), Timing belt M284 (7), Timing belt M386 (8),
Timing belt M214(203dpi) / Timing belt M250(305dpi) (9),and Timing belt M194(203dpi) / Timing belt
M230(305dpi) (10).
5
Reverse the above procedures for reassembly.
7.
After replacement, adjust the ribbon tension according to the procedure in Section 6.19 Adjusting Timing
8.
Belt Tension .
CAUTION:
A PROPERLY TENSIONED BELT WILL BE JUST ENOUGH TO PREVENT SLIPPAGE.
AN OVERLY TENSIONED BELT WILL EXCESSIVELY INCREASE DRAG ON THEIR
PULLEYS AND INCREASE COMPONENT WEAR.
TG3 Series Service Manual
tension bracket
7
10
tension bracket
Section 7: Replacement Procedures
6
9
8
Page 7-15