Adjusting Lcd Brightness; Adjusting Factory Offset - SATO 9001226(A) Service Manual

Section 6: Checks and Adjustment Procedures

6.13 ADJUSTING LCD BRIGHTNESS

6.13.1 To adjust the LCD screen Brightness in Normal Mode
In Normal mode (ONLINE or Offline), press the
6.13.2 To adjust the LCD screen Brightness in Factory Mode
Enter to MAINTENANCE MODE, select FACTORY MODE and then press
1.
FEED button. Refer to Section 4.14 Maintenance Mode for more details.
In the Factory mode, COUNTER CLEAR screen is first displayed. Press
2.
FEED repeatedly until LCD BRIGHTNESS is displayed.
Press arrow buttons to adjust the LCD screen brightness.
3.
/
The setting range is between 00 and 32.
Press FEED button to save the setting.
4.
Note:
This setting cannot be cleared by resetting the counter.

6.14 ADJUSTING FACTORY OFFSET

This adjustment regulates the label positioning for print and offset simultaneously. Factory Offset modification
is performed via a potentiometer that is part of the potentiometer complex integrated to the main circuit board
accessible behind the left housing cover.
To perform this adjustment, initiate normal printing or a test print and adjust potentiometer VR1 (F.OFFSET)
until the correct position is achieved.
Turn clockwise
Page 6-34
/ arrow buttons repeatedly to adjust the LCD Brightness.
Turn counter
clockwise
(F. OFFSET)
VR1
CHK
CONT PCB
TG3 Series Service Manual