SATO 9001226(A) Service Manual page 101

4.15 SERVICE MODE (Cont'd)
Menu
TG3 Series Service Manual
SENSOR LEVEL MODE
Displaying the current level of I-mark sensor on the upper part of the display.
Adjust the sensor level offset with
how soon the sensor responds to an oncoming I-Mark. The adjustment range
is between 0 and 63 and is shown on the bottom line of the display. The default
setting is 31.
Press arrow buttons to save the setting and switch to slice level display.
/
The slice level is calculated automatically and displayed on the bottom line.
You can also adjust the slice level by pressing
range is between 0.0 and 3.2. (adjustable in increments of 0.1)
Note: The slice level is automatically set by firmware when the value is set to 0.0.
Press FEED button to save the setting and proceed to the next screen.
Displaying the current level of gap (center hole) sensor on the upper part of the
display. Adjust the sensor level offset with
determined how soon the sensor responds to an oncoming gap (center hole).
The adjustment range is between 0 and 63 and is shown on the bottom line of
the display. The default setting is 31.
Press arrow buttons to save the setting and switch to slice level display.
/
The slice level is calculated automatically and displayed on the bottom line.
You can also adjust the slice level by pressing
range is between 0.0 and 3.2. (adjustable in increments of 0.1)
Note: The slice level is automatically set by firmware when the value is set to 0.0.
Press FEED button to save the setting and proceed to the next screen.
Displaying the current level of side hole sensor.
[0] indicates hole detection and [1] indicates tag position.
Check the condition of sensor and adjust the sensor level to detect hole cor-
rectly. The input range is between 0 and 63.
The initial value is 31.
Displaying the current status of edge sensor.
[0] indicates edge detection and [1] indicates tag position.
Check the condition of sensor and adjust the sensor level to detect edge of tag
correctly. The input range is between 0 and 63.
The initial value is 31.
Displaying the current status of jump hole sensor.
[0] indicates hole detection and [1] indicates tag position.
This screen only displays status of sensor, as jump hole sensor is adjusted with
potentiometer (VR10: J.HOLE) on the Main PCB.
Check the condition of jump hole sensor to see if it detects a jump hole properly.
Displaying the current status of cutter sensor.
Switch the type of cutter sensors with
GAP/CH : [0] indicates gap position and [1] indicates tag position.
I-MARK : [0] indicates tag position and [1] indicates I-mark position.
EDGE : [0] indicates edge position and [1] indicates tag position.
Cutter sensor can be adjusted by the volume (potentiometer) on the cutter unit.
Therefore, this screen shows sensor state only. Make sure to check and adjust
the cutter sensor condition to detect paper properly.
Section 4: Operation and Configuration
Description
arrow buttons. This offset determined
/
arrow buttons. The input
/
arrow buttons. This offset
/
arrow buttons. The input
/
arrow buttons.
/
Page 4-61