Upgrading the G350 firmware
4. Remove the USB mass storage device from the PC, and insert it into the G350 USB port.
5. Run CLI commands to copy the firmware files from the USB mass storage device to the
G350. See
CLI Commands for upgrading G350 firmware via a USB device
You can use CLI commands to upload an upgrade file from a USB mass storage device to the
G350. You must use the specific path to the file on the USB mass storage device.
Use the copy usb EW_archive command to upgrade the Java applet for Avaya G350
●
Manager software from a USB mass storage device
Use the copy usb module command, followed by the slot number of the module you
●
want to upgrade, to upgrade the firmware on a media module from a USB mass storage
device
Use the copy usb SW_imageA command to upgrade the G350 firmware into Bank A
●
from a USB mass storage device
Use the copy usb SW_imageB command to upgrade the G350 firmware into Bank B
●
from a USB mass storage device
Example upgrade using the CLI via a USB device
To upgrade the firmware of an MM712 media module in slot 3 from a USB mass storage device
where the upgrade file is located in the directory \temp\, use the following command:
copy usb module usb-device0 \temp\mm712v51.fdl 3
Downloading G350 firmware files to a local PC
1. Access the
2. Navigate to G350 Media Gateway downloads.
3. Locate the file names that match the files listed in your installation worksheet. See
for sample firmware file names.
4. Double-click the file name of the file you want to download. A File Download window
appears.
5. Select Save this file to disk.
6. Save the file to a directory on the local PC.
92 Installation and Upgrades for the Avaya G350 Media Gateway
CLI Commands for upgrading G350 firmware via a USB device
www.avaya.com/support
website.
on page 92.
Table 5