Configuring A D-Channel Interface To Support Pri/Ni2 Using Ld 17 - Avaya Communication Server 1000 Installation And Commissioning Manual

Hide thumbs Also See for Communication Server 1000:
Table of Contents

Advertisement

Configure an E1/T1 card
For the PRI Gateway, digital trunk loop and D-channel configuration is not supported on TMDI
card types.
nB+D PRI is supported by the PRI Gateway but is not shown in these examples. For more
information about configuring nB+D PRI, see Avaya ISDN Primary Rate Interface Features
Fundamentals (NN43001-569-B1).
Use

Configuring a D-channel interface to support PRI/NI2 using LD 17

configure the PRI/NI2 D-channel interface in the PRI Gateway.
Configuring a D-channel interface to support PRI/NI2 using LD 17
1. Log on to the CS 1000E.
2. To access LD 17, enter:
3. Enter the responses shown in
86
Media Gateway 1000E PRI Gateway Installation and Commissioning
LD 17
(LD 17)
on page 86.
Table 19: PRI/NI2 D-channel interface configuration (LD 17)
Prompt
Response
REQ
CHG
TYPE
ADAN
ADAN
NEW DCH xx
CTYP
MSDL
MG_CARD supl sh card
PORT
0 - 1
Comments? infodev@avaya.com
Table 19: PRI/NI2 D-channel interface configuration
Description
Change existing data.
Action device and number.
Add a D-channel on logical port 0 - 254.
D-channel configuration on MSDL card.
MSDL= NTBK51AA/NTBK51AAE5/
NTBK51CAE5 (and later) downloadable D-
channel daughterboard.
TMDI is not supported for MGP.
The physical card for the digital loop association
to the PRI Gateway.
The format is: superloop, shelf number, card
number.
Important:
Even card numbers are applicable (that is, 2,
4, 6, 8).
Warning:
DO NOT use odd loop numbers. Odd loop
numbers may cause issues with existing
equipment.
Port number of the NTBK51AA/NTBK51AAE5/
NTBK51CAE5 for the D-channel.
on page 86 to
March 2013

Advertisement

Table of Contents
loading

This manual is also suitable for:

Media gateway 1000e priMg 1000e pri

Table of Contents