Sulb-1031; Sulb-1032; Sulb-1033 - Brocade Communications Systems SN3000B Reference

Recommended The firmwareDownload command will continue after the switch has rebooted. Run the
Action firmwareDownloadStatus command to monitor progress. If the problem persists, contact your
switch service provider.
Severity WARNING

SULB-1031

Message
<Sequence Number> AUDIT, <timestamp>, [SULB-1031], WARNING, FIRMWARE,
<event-initiator-details>, <event-location>, , The switch is relocating an
internal firmware image.
Probable Cause Indicates the switch has rebooted with the new firmware and is relocating the AP firmware.
Recommended Wait for the operation to complete.
Action
Severity WARNING

SULB-1032

Message
<Sequence Number> AUDIT, <timestamp>, [SULB-1032], WARNING, FIRMWARE,
<event-initiator-details>, <event-location>, , Relocating an internal firmware
image on the CP.
Probable Cause Indicates the switch has started firmware download to the co-CPU.
Recommended Wait for the operation to complete.
Action
Severity WARNING

SULB-1033

Message
<Sequence Number> AUDIT, <timestamp>, [SULB-1033], WARNING, FIRMWARE,
<event-initiator-details>, <event-location>, , Switch has completed relocating
the internal firmware image.
Probable Cause Indicates the firmwareDownload process has completed on the switch.
Recommended Run the firmwareShow command to verify the firmware versions. Run the switchShow command to
Action make sure the switch is enabled.
Severity WARNING
Fabric OS Message Reference
53-1002448-01
137
SULB-1031
863