Bl-1039; Bl-1041; Bl-1045 - Brocade Communications Systems SN3000B Reference

Recommended Restart the switch. If the message persists, replace the switch.
Action
Severity CRITICAL

BL-1039

Message
<timestamp>, [BL-1039], <sequence-number>,, CRITICAL, <system-name>, Inconsistent
FPGA image version detected, faulting the blade in slot <slot number>.
Probable Cause Indicates that the FPGA image version is incompatible with the software version.
Recommended Power cycle the blade. If the message persists, replace the blade.
Action
Severity CRITICAL

BL-1041

Message
<timestamp>, [BL-1041], <sequence-number>,, CRITICAL, <system-name>, Dynamic area
mode is enabled on default switch, Faulting the blade w/ ID <Blade ID of blade
that has the mini SFP+ that does not support it> in slot <slot number> as it does
not support this mode.
Probable Cause Indicates that the blade does not support dynamic area mode on default switch.
Recommended Turn off the dynamic area mode through Configure CLI.
Action
Severity CRITICAL

BL-1045

Message
<timestamp>, [BL-1045], <sequence-number>,, ERROR, <system-name>, mini SFP+ (SN:
<mini SFP+ serial number>) is only supported in certain high port count blades,
not blade in slot <slot number of blade that has the mini SFP+> w/ ID <Blade ID of
blade that has the mini SFP+ that does not support it>.
Probable Cause Indicates that the mini (form factor) SFP+ is supported only by a certain type of blade (FC8-64),
but it can be inserted in other blades.
Recommended Replace the mini SFP+ with an SFP or SFP+.
Action
Severity ERROR
Fabric OS Message Reference
53-1002448-01
7
BL-1039
83