Port-1003; Port-1004; Port-1005; Port System Messages - Brocade Communications Systems SN3000B Reference

PORT System Messages

PORT-1003

Message
<timestamp>, [PORT-1003], <sequence-number>,, WARNING, <system-name>, Port <port
number> Faulted because of many Link Failures
Probable Cause Indicates that the specified port is now disabled because the link on this port had multiple failures
that exceeded an internally set threshold on the port. This problem is typically related to hardware.
Recommended Check and replace (if necessary) the hardware attached to both ends of the specified port number,
Action including:
•
•
•
When finished checking the hardware, perform the portEnable command to re-enable the port.
Severity WARNING

PORT-1004

Message
<timestamp>, [PORT-1004], <sequence-number>,, INFO, <system-name>, Port <port
number> (<port number (hex)>) could not be enabled because it is disabled due to
long distance.
Probable Cause Indicates the specified port is not enabled because other ports in the same group have used the
buffers for this port group. This happens when other ports were configured to be long distance.
Recommended To enable this port, reconfigure the other E_Ports so they are not long distance or change the other
Action E_Ports so they are not E_Ports. This will free some buffers and allow this port to be enabled.
Severity INFO

PORT-1005

Message
<timestamp>, [PORT-1005], <sequence-number>,, WARNING, <system-name>, Slot <slot
number> port <port on slot> does not support configured L_port. Issue portCfgLport
to clear configuration.
Probable Cause Indicates the specified port is configured to be an L_port, but the port does not support L_port. If
an L_port is connected, then the port will be disabled because the port does not support L_port. If
an E_port or F_port is connected, then the port will not come up since it is configured to be an
L_port.
Fabric OS Message Reference
53-1002448-01
the media (SFPs)
the cable (fiber optic or copper ISL)
the attached devices
Chapter
83
549