Auth-1004; Auth-1005; Auth-1006; Auth-1007 - Brocade Communications Systems SN3000B Reference

5

AUTH-1004

AUTH-1004
Message
<timestamp>, [AUTH-1004], <sequence-number>,, ERROR, <system-name>, Failed to set
<data type> type to <setting value>.
Probable Cause Indicates that the authUtil command has failed to set the authentication configuration value. The
data type is either authentication type, DH group type, or policy type.
Recommended Retry the authUtil command.
Action
Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1005

Message
<timestamp>, [AUTH-1005], <sequence-number>,, ERROR, <system-name>,
Authentication file does not exist: <error code>.
Probable Cause Indicates an authentication file corruption.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1006

Message
<timestamp>, [AUTH-1006], <sequence-number>,, WARNING, <system-name>, Failed to
open authentication configuration file.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
Action and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING

AUTH-1007

Message
<timestamp>, [AUTH-1007], <sequence-number>,, ERROR, <system-name>, The proposed
authentication protocols are not supported: port <port number>.
Probable Cause Indicates that the proposed authentication protocol type or types are not supported by the local
specified port.
56 Fabric OS Message Reference
53-1002448-01