Sulb-1039; Sulb-1040; Sulb-1041; Sulb-1042 - Brocade Communications Systems SN3000B Reference

SULB-1039

Message
<timestamp>, [SULB-1039], <sequence-number>, INFO, <system-name>, CP has
completed relocating the internal firmware image.
Probable Cause Indicates that the firmwareDownload command process has been completed normally on the CP.
Recommended Run the firmwareShow command to verify the firmware versions.
Action
Severity INFO

SULB-1040

Message
<timestamp>, [SULB-1040], <sequence-number>, WARNING, <system-name>, An error has
occurred during relocation of the internal image on the CP.
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet
failure.
Recommended Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
Action command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.
Severity WARNING

SULB-1041

Message
<timestamp>, [SULB-1041], <sequence-number>, INFO, <system-name>, Firmware has
been activated successfully on standby CP.
Probable Cause Indicates the firmwareActivate command has completed successfully on standby CP.
Recommended No action is required. The firmwareActivate command has completed on standby CP as expected.
Action
Run the firmwareShow command to verify the firmware versions.
Severity INFO

SULB-1042

Message
<timestamp>, [SULB-1042], <sequence-number>, INFO, <system-name>,
Firmwareactivate command has completed successfully.
Probable Cause Indicates the firmwareActivate command has completed successfully and switch firmware has
been updated.
Fabric OS Message Reference
53-1002448-01
101
SULB-1039
705