Sec-1087; Sec-1088; Sec-1089 - Brocade Communications Systems SN3000B Reference

94

SEC-1087

Recommended Reduce the number of entries in some policies to decrease the security database size.
Action
Severity ERROR
SEC-1087
Message
<timestamp>, [SEC-1087], <sequence-number>,, ERROR, <system-name>, The security
database is larger than the data distribution limit of fabric <fabric data
distribution limit> bytes.
Probable Cause Indicates the security database has more data than can be distributed to some of the switches in
the fabric.
Recommended Reduce the number of entries in the security policies to decrease the security database size.
Action
Severity ERROR

SEC-1088

Message
<timestamp>, [SEC-1088], <sequence-number>,, ERROR, <system-name>, Cannot execute
the command. Please try later.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1089

Message
<timestamp>, [SEC-1089], <sequence-number>,, ERROR, <system-name>, Policy name
<policy name> was not found.
Probable Cause Indicates the security policy name in the secPolicyAdd command does not exist.
Recommended Create the appropriate security policy first, then use its name in the secPolicyAdd command to add
Action new members.
Severity ERROR
598 Fabric OS Message Reference
53-1002448-01