Swch-1021; Swch-1022 - Brocade Communications Systems SN3000B Reference

SWCH-1021

Message
<timestamp>, [SWCH-1021], <sequence-number>,, WARNING, <system-name>, HA state
out of sync: Standby CP (ver = <standby SWC version>) does not support Dynamic
area on default switch (Active CP version = <active SWC version>).
Probable Cause Indicates the standby control processor (CP) does not support dynamic area on default switch.
Recommended Load a firmware version on the standby CP that supports dynamic area on default switch, using the
Action firmwareDownload command.
Severity WARNING

SWCH-1022

Message
<timestamp>, [SWCH-1022], <sequence-number>,, WARNING, <system-name>, Port:<port
number> have been disabled due to port address conflict while enabling FMS mode.
Probable Cause Indicates the switch has ports with FMS reserved areas (0xFE or 0xFF) which are not supported in
FMS mode.
Recommended This is a normal event; no action is required.
Action
Refer to the Fabric OS Administrator's Guide for more information.
Severity WARNING
Fabric OS Message Reference
53-1002448-01
102
SWCH-1021
713