Sec-1083; Sec-1084; Sec-1085; Sec-1086 - Brocade Communications Systems SN3000B Reference

SEC-1083

Message
<timestamp>, [SEC-1083], <sequence-number>,, ERROR, <system-name>, Name already
exists.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1084

Message
<timestamp>, [SEC-1084], <sequence-number>,, ERROR, <system-name>, Name exists
for different type <Policy name>.
Probable Cause Indicates the specified policy already exists.
Recommended No action is required.
Action
Severity ERROR

SEC-1085

Message
<timestamp>, [SEC-1085], <sequence-number>,, ERROR, <system-name>, Failed to
create <policy name>.
Probable Cause Indicates that the security policy was not created.
Recommended Check that the current policy configuration is valid. For example, the RSNMP policy cannot exist
Action without the WSNMP policy.
Severity ERROR

SEC-1086

Message
<timestamp>, [SEC-1086], <sequence-number>,, ERROR, <system-name>, The security
database is too large to fit in flash.
Probable Cause Indicates the security database has more data than the flash can accommodate.
Fabric OS Message Reference
53-1002448-01
94
SEC-1083
597