Ficu-1007; Ficu-1008; Ficu-1009; Ficu-1010 - Brocade Communications Systems SN3000B Reference

FICU-1007

Message
<timestamp>, [FICU-1007], <sequence-number>,, WARNING, <system-name>, <function
name>: Failed to allocate memory while performing <message>.
Probable Cause Indicates that memory resources are low. This may be a transient problem.
Recommended Check the memory usage in the switch using the memShow command.
Action
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Severity WARNING

FICU-1008

Message
<timestamp>, [FICU-1008], <sequence-number>,, WARNING, <system-name>, FMS mode
has been enabled. Ports:<port numbers> have been disabled due to port address
conflict.
Probable Cause Indicates that the specified ports were disabled when FMS mode was enabled. This is due to a port
address conflict or the port address being reserved for the CUP management port.
Recommended No action is required.
Action
Severity WARNING

FICU-1009

Message
<timestamp>, [FICU-1009], <sequence-number>,, WARNING, <system-name>, FMS Mode
enable failed due to insufficient frame filtering resources on some ports.
Probable Cause Indicates that the frame filtering resources required to enable FMS mode were not available on
some of the ports.
Recommended Execute the perfDelFilterMonitor command to delete the filter-based performance monitors used
Action on all ports to free up the resources.
Severity WARNING

FICU-1010

Message
<timestamp>, [FICU-1010], <sequence-number>,, WARNING, <system-name>, FMS Mode
enable failed due to port(s) with areas 0xFE or 0xFF is(are) connected to
device(s).
Probable Cause Indicates that FMS mode was not enabled because ports with 0xFE or 0xFF areas are connected to
the devices.
Fabric OS Message Reference
53-1002448-01
39
FICU-1007
323